With the concern around the issue of the Japanese nuclear reactors as a result of the massive earthquake, it is helpful to be reminded of the actual danger, as this article from the Wall Street Journal does.
An excerpt.
“Even while thousands of people are reported dead or missing, whole neighborhoods lie in ruins, and gas and oil fires rage out of control, press coverage of the Japanese earthquake has quickly settled on the troubles at two nuclear reactors as the center of the catastrophe.
“Rep. Ed Markey (D., Mass.), a longtime opponent of nuclear power, has warned of "another Chernobyl" and predicted "the same thing could happen here." In response, he has called for an immediate suspension of licensing procedures for the Westinghouse AP1000, a "Generation III" reactor that has been laboring through design review at the Nuclear Regulatory Commission for seven years.
“Before we respond with such panic, though, it would be useful to review exactly what is happening in Japan and what we have to fear from it.
“The core of a nuclear reactor operates at about 550 degrees Fahrenheit, well below the temperature of a coal furnace and only slightly hotter than a kitchen oven. If anything unusual occurs, the control rods immediately drop, shutting off the nuclear reaction. You can't have a "runaway reactor," nor can a reactor explode like a nuclear bomb. A commercial reactor is to a bomb what Vaseline is to napalm. Although both are made from petroleum jelly, only one of them has potentially explosive material.
“Once the reactor has shut down, there remains "decay heat" from traces of other radioactive isotopes. This can take more than a week to cool down, and the rods must be continually bathed in cooling waters to keep them from overheating.
“On all Generation II reactors—the ones currently in operation—the cooling water is circulated by electric pumps. The new Generation III reactors such as the AP1000 have a simplified "passive" cooling system where the water circulates by natural convection with no pumping required.
“If the pumps are knocked out in a Generation II reactor—as they were at Fukushima Daiichi by the tsunami—the water in the cooling system can overheat and evaporate. The resulting steam increases internal pressure that must be vented. There was a small release of radioactive steam at Three Mile Island in 1979, and there have also been a few releases at Fukushima Daiichi. These produce radiation at about the level of one dental X-ray in the immediate vicinity and quickly dissipate.
“If the coolant continues to evaporate, the water level can fall below the level of the fuel rods, exposing them. This will cause a meltdown, meaning the fuel rods melt to the bottom of the steel pressure vessel.
“Early speculation was that in a case like this the fuel might continue melting right through the steel and perhaps even through the concrete containment structure—the so-called China syndrome, where the fuel would melt all the way to China. But Three Mile Island proved this doesn't happen. The melted fuel rods simply aren't hot enough to melt steel or concrete.”
